Job Stories

When this Newfield, ME homeowner noticed a crack had opened on their concrete basement wall, they immediately looked for things to have done to keep water from leaking through. They soon heard about us at TC Hafford Basement Systems from their realtor and called us right away to set up their free estimate! Once they got their estimate, they gave us the go-ahead to seal this crack. A few days later, our installation crew arrived at the home to get started on sealing the crack with a FlexiSpan seal. To prime the crack for sealant, a coarse brush was used to scrape away any debris. Next, an initial layer of sealant was applied within and around the crack. This was soon covered over with a foam mat, running the length of the crack. A final layer of sealant was laid over the foam, to complete the FlexiSpan seal. With the foam core, this seal can adjust to slight shifts in theshape of the crack while maintaining a water-tight seal! Now this crack won't become a moisture problem in the future. This homeowner can rest assured the FlexiSpan seal will lock out any outside water.

Living in Shapleigh, ME, a homeowner was experiencing trouble keeping their basement water-free. In order to use the space, they needed a way to keep the water out for good. To get this done, they searched online for a solution. That's where they found the answer to their wet basement problem, TC Hafford Basement Systems. They called us soon after and we got to work! When our installation crew arrived at the home, they began work on installing WaterGuard piping. This required a shallow trench to be excavated from the perimeter of the basement floor. Inside this new trench, the WaterGuard piping was buried beneath a fresh coat of loose rocks and concrete. Now, within the floor, the WaterGuard will capture any moisture leaking through the floor of the basement. To clear the moisture from the air, a SaniDry XP dehumidifier was also installed. This device will take in the damp air from the basement, separating the moisture from it and circulating the dried air back into the space. To remove all of the water collected in the WaterGuard and SaniDry, a SuperSump sump pump was installed in the basement floor with an UltraSump attached. The SuperSump will take the water and force it up and out of the home through a PVC discharge line. The SuperSump can handle over 2,600 gallons of water every hour! The attached UltraSump backup battery will ensure the SuperSump continues to remove water even when the home is without power. Outside the home, two additions were made to the discharge line before our crew was finished. The first addition was an IceGuard pipe section attached just beyond where the line leaves the home. This pipe piece has speical holes built in which allow for water trapped by ice or debris to escape before backing-up into the home. Finally, a LawnScape piece was placed on the end of the line, giving the water a place to exit onto the ground a distacne from the home. Now that this homeowner has a waterproofed basement, they can use the space however they choose. The WaterGuard piping and sump system will keep this basement from flooding in the future!

Over time, stone foundations begin to break down, allowing for gaps to form that allow in water, creating a breeding ground of high humidity and mold growth. Gaps in a foundation can also lead to shifting, which creates an unstable foundation that could potentially ruin the health of a home and lead to damage if not properly fixed. Typically, a failing foundation would have to be replaced by lifting a home and pouring a new foundation. This would involve the homeowner moving out of their home for a period of time and having to make extensive changes to plumbing and electrical during the lift. StableLock by TC Hafford Basement Systems saves the current foundation and prevents the homeowner from having to go through the trouble of lifting their home.       This Shapleigh, ME, homeowner had a failing foundation that was allowing water in and creating an unhealthy home environment. This has been their home for over 40 years, and it was important to them to fix the situation promptly. The homeowner called TC Hafford Basement Systems and System Design Specialist Michael Penna met with the homeowner for a free estimate. Michael Penna and the homeowner worked together to design a system that would save the existing foundation and protect the homeowner from having to move out of their home for repairs. The StabeLock system features a new foundation wall that is poured and secured to the existing failing wall. This not only saves the homeowner from extensive home renovation but can be finished in as little as two days without disrupting the home, all while saving the homeowner money. The homeowner is able to rest easy now knowing that their home is protected and their foundation won’t cause them anymore issues.

Wanting to cure their humidity and puddle problems in their basement, this Seabrook, NH homeowner called TC Hafford Basement Systems for help. System Design Specialist Rick Russell drove out to meet with the homeowner for a free estimate and worked with them to design a system that would meet their needs and protect the health of their home.   Replacing the old sump pump was a must for the customer to make sure water would be pumped out of the basement before it had a chance to form any puddles. A SuperSump was installed in place of the old sump and connected to a Buried Exterior Discharge line that takes the water far from the home where it won’t cause any problems. IceGuard was installed on the Discharge line to prevent ice from building up during the cold winter months, ensuring that the system will run smoothly year-round. Finally, a SaniDry Sedona Dehumidifier was installed in the basement to keep humidity at a safe level, preventing mold, musty odors, and keeping the space safe for storage. Now this Seabrook, NH home is protected, and the homeowner can use their basement to its fullest potential.

In Berwick, Maine, Andrea had an existing sump pump and dehumidifier, but still experienced a wet basement whenever it rained. After searching online for a solution, Andrea came to us. Once our representative Mike Morin took a look, a team was sent out to get to work. TC Hafford started by installing a WaterGuard basement waterproofing system around the perimeter of the basement. This system is used to collect any water that might attempt to flow into the basement through the walls or up through the floor. This WaterGuard system was then connected through to a newly installed SuperSump sump pump, which replaced the old sump. This new sump pump pumps any water fed into it to the outside. Finally, the crew used an IceGuard pipe outside the house to prevent the water from being blocked. The IceGuard is a special piece of pipe that allows water to flow even when the rest of the pipe is blocked off by ice or other debris. After finishing these additions to the basement, Andrea now no longer has to worry about water in the slightest.

With a massive hole in their foundation, this Berwick, ME, homeowner was worried about their foundation collapsing. Not willing to risk this happening, the homeowner scheduled a free estimate with TC Hafford Basement Systems after finding us online. System Design Specialist Rick Russell met with the homeowner and worked with them to design a system that would solve their foundation troubles.   In situations where the foundation is failing like this, the home would typically need to be lifted and a new foundation would be poured, but not with StableLock Wall System. StableLock was created to be a permanent fix for failing foundations, and the homeowner never has to leave the house. StableLock was created to meet the demand of failing rock foundations in Maine. StableLock uses modern shoring methods to fill the voids in the existing wall and stabilize it. The homeowner is no longer worried about their foundation failing, and they saved money all while protecting their home from any future damage that comes along with a bad foundation.

A homeowner in Rollinsford had a basement with steel framed windows. These windows, over time, lost their alignment with the rest of the basement wall. This small crack would allow for water to enter in through the window during rain. This was an issue that needed to be solved ASAP. The homeowner took to the internet to find a solution. They soon came across TC Hafford Basement Systems and chose us to get the job done. Once on the scene, we removed the old windows, these weren’t going to be needed anymore. We then started on installing four EverLast Windows. These windows fit snugly into the previous windows ports, sealing off the basement from exterior moisture. Now this homeowner no longer needs to worry about water leaking into their basement through the window frames.

A homeowner in Hiram was looking to put their home up for sale. But with the amount of water that would regularly gather within the basement during heavy rains, they would have a hard time finding a buyer. Taking to the internet to find a solution to their water problem, the homeowner soon discovered TC Hafford Basement Systems. They contacted us right away and we began work on the basement. We started by excavating the inside perimeter of the basement floor. This gave us a trench where we could lay our WaterGuard piping system. These pipes will capture any and all water as it tries to enter the basement through the walls or floor. The WaterGuard is then covered with loose rocks and cement to hide it beneath the floor without preventing it from functioning. The water captured by the WaterGuard is then guided to the sump, where we installed a SuperSump sump pump. This pump will push all the gathered water up and out of the basement through a PVC discharge line. On the exterior of the home, this discharge line has a special IceGuard piece attached. The IceGuard is designed to allow water to exit the pipe should the lower end become blocked by ice or other debris. These three products working together will maintain a dry basement in this home for many years to come; Allowing the homeowner to sell the home without any issues involving a leaking basement.

  This Hampton, NH home was purchased two years ago by the current homeowner and they had a few issues that needed to be addressed in the crawlspace so TC Hafford Basement Systems got the call. System Design Specialist Peter Folsom met with the homeowner and put together a plan on how to lift the sagging floor and protect the crawlspace from moisture.   CleanSpace is a proprietary crawl space encapsulation system developed by Basement Systems to address moisture, water intrusion, and mold problems in residential and commercial crawl spaces. The CleanSpace system typically involves the following components and steps: Moisture Barrier: CleanSpace utilizes a heavy-duty, durable, and puncture-resistant plastic liner that acts as a moisture barrier. This liner is designed to prevent moisture from the ground, walls, and air from entering the crawl space. Drainage Matting: A dimpled drainage matting is often installed beneath the CleanSpace liner to create an airspace and allow any water or moisture to drain away. Vapor Barrier: The CleanSpace liner acts as a vapor barrier, preventing the transmission of water vapor and moisture from the ground into the crawl space. Sealing and Insulation: The CleanSpace system involves sealing vents, gaps, and cracks to prevent outside air and moisture infiltration. Insulation options may also be provided to enhance energy efficiency. Dehumidification: A dehumidifier is recommended to control humidity levels in the crawl space, reducing the risk of mold growth and musty odors. The CleanSpace system aims to transform a damp and musty crawl space into a clean, dry, and healthier environment by effectively managing moisture and preventing water-related issues. It can help improve indoor air quality, protect structural integrity, and create a more comfortable living space above the crawl space. SmartJacks are engineered steel support posts that are strategically installed in the crawl space or basement of a building to stabilize and reinforce sagging or settling floors. These support posts are adjustable, allowing for precise leveling and support customization to address the specific needs of each situation. Key features of SmartJacks include: 1.      Strong and Durable: SmartJacks are made from high-quality steel, ensuring long-lasting durability and reliability. They are designed to withstand heavy loads and provide reliable support for sagging floors. 2.      Adjustable Design: The adjustable design of SmartJacks allows for precise leveling and support customization. Skilled technicians can easily adjust the height of the support posts to lift and stabilize floors to their original position. 3.      Customizable Installation: SmartJacks can be installed in various configurations to suit different foundation layouts and floor support requirements. TC Hafford Basement Systems’ professionals assess the specific needs of the building and determine the optimal placement and quantity of SmartJacks for effective floor stabilization. 4.      Transfer of Load: By providing solid support beneath sagging or settling floors, SmartJacks transfer the weight of the structure to more stable soil or load-bearing strata, reducing stress on the foundation and preventing further damage. 5.      Professional Installation: SmartJacks are typically installed by trained and certified professionals from TC Hafford Basement Systems. Their expertise ensures proper placement and adjustment, maximizing the effectiveness of the support system. Benefits of using SmartJacks include increased structural stability, improved floor leveling, prevention of further damage, and the potential to regain the original height and integrity of the floors. Additionally, SmartJacks come with a warranty, providing peace of mind for property owners.    

Molly in Cornish was experiencing trouble with her crawlspace. It would collect puddles of water whenever it would rain. This needed to be addressed as soon as possible. Soon after seeing an ad on television, Molly gave TC Hafford a call. We had a crew out in no time to get to work! The interior perimeter of the crawlspace was covered with a Drainage Matting to prevent the water from making its way toward the center of the crawlspace. We then lined the crawlspace with a CleanSpace Liner. This is a clean sheet of plastic that encapsulates the entire crawlspace, save for the ceiling. This will lock out any and all water trying to enter the crawlspace. Though moisture still might be able to sneak into the crawlspace through other means. This is why we installed a SaniDry CX Dehumidifier. This dehumidifier will maintain a dry atmosphere within the crawlspace. Preventing any mold growth or structural damage to the house.